Rank: Member
Groups: Member
Joined: 7/18/2009
Posts: 26
Points: 78
Location: williamsport
|
hoss,
do you have any test programs I can run on my minimill to show off and tune mach3? I just have your 3 axis conversion with the x2 minill and probotix side step stepper kit. I would like to have this all running top notch by the end of the weekend.
Also do I just need the z axis bearing plate, z axis stepper mount plate, and the 2 z axis side plates now? I do not need the inner column block and the spacer block with the new revisions correct?
|
Rank: Administration
Groups: Administration
Joined: 6/28/2008
Posts: 215
Points: 407
Location: Follansbee, WV
|
Mach has a few test programs loaded including the roadrunner engraving that many people use.
just click File/Load G-Code and browse to the Mach3/GCode folder.
You could also use some of the wizards to generate some simple programs to put it thru it's paces.
You're right, you wont need the inner block and spacer if you go with the side supports instead.
Hoss
Gosh, you've... really got some nice toys here.-Roy Batty
|
