|
|
Rank: Member
Groups: Member
Joined: 7/18/2009
Posts: 26
Points: 78
Location: williamsport
|
ran quite a few test programs such as the roadrunner and mudflap girl with a pencil. I will be posting video tomorrow. What is the next step as I have figured out the homing, tuned the motors to the best that i can...
also hoss would you be willing to cut one of your touch probe setups? I saw ernie and your vids and like the setup of yours. It works just the same correct?
|
|
Rank: Administration
Groups: Administration
Joined: 6/28/2008
Posts: 215
Points: 407
Location: Follansbee, WV
|
one of these edge finders from Enco work great too. http://www.use-enco.com/CGI/INSRIT?PMAKA=307-3436remove the battery and the tip is isolated just like mine with a groove to clip on to. Hoss
Gosh, you've... really got some nice toys here.-Roy Batty
|
|
Rank: Member
Groups: Member
Joined: 7/18/2009
Posts: 26
Points: 78
Location: williamsport
|
whats the good word on the next step or am i ready to mount hard limit switches and cut metal again...?
|
|
Rank: Administration
Groups: Administration
Joined: 6/28/2008
Posts: 215
Points: 407
Location: Follansbee, WV
|
yeah, mount your home switches, get them wired up and configure mach and you should be ready to roll.
hoss
Gosh, you've... really got some nice toys here.-Roy Batty
|
|
Rank: Administration
Groups: Administration
Joined: 6/28/2008
Posts: 215
Points: 407
Location: Follansbee, WV
|
Don't forget to tram the mill and then run the Mach 3 Axis Calibration too. Hoss
Gosh, you've... really got some nice toys here.-Roy Batty
|
|
|
Guest |
